= Simple scaling =
Open again a test image in 'UVMAT_DEMO01_pair'.(accessible on http://servforge.legi.grenoble-inp.fr/pub/soft-uvmat/)

We shall use the diameter of the half cylinder visible on the upper let of the image to set the calibration. Its physical diameter 
is 2cm. The corresponding diameter in pixels can be obtained with the ruler displayed by the menu bar '''Tools/ruler''' of uvmat.

First zoom on the cylinder to optimize the precison. Select '''zoom on''', press the left mouse button and adjust the field with the directional key board arrows. Then unselect '''zoom on''' to allow for other mouse actions (otherwise zoom has priority). It is also useful to increase the contrast at the cylinder edge by setting '''MaxA''' to 100 in the frame '''Scalar''' (right side of uvmat).

Then select the menu bar '''Tools/ruler''', press the left hand mouse button on the cylinder edge, draw a diameter keeping the mouse pressed, release it on the opposite edge. The length in pixels, 140, is displayed, so the scaling factor is 140/2=70 pixels/cm. 

Open the menu bar '''Tools/geometric calibration'''. A new GUI '''geometry_calib''' appears on the right side. Activate the upper menu bar '''!Tools/Set scale''' on this GUI and introduce the value 70 in the edit box which pops up, and validate with '''OK'''. A set of calibration point coordinates appears in the table '''[!ListCoord]''' of the GUI. 

To see the calibration points on the image, first display the whole image by unselecting '''fix''' (tag '''[!CheckFixLimits]''') in the frame '''Coordinates''' of uvmat. Then press '''PLOT PTS''' in '''geometry_calib'''.

To perform the calibration, press '''APPLY''', first with the default option 'rescale' in '''calib_type'''.  The image is now displayed in phys coordinates. 


= Calibration with reference points =

An alternative method of calibration consists of using a set of reference points whose physical coordinates are known. Open with '''uvmat''' an image in 'UVMAT_DEMO06_PIVconvection/Dalsa1' (accessible on http://servforge.legi.grenoble-inp.fr/pub/soft-uvmat/)

Select in the menu bar '''Tools/geometric calibration'''. Mark the four box corners of the box with the mouse (left hand button). Their coordinates in pixels are displayed in the two last column of the table '''!ListCoord''' in the GUI '''geometry_calib'''. To clear the table for corrections push the button '''CLEAR_PTS''', or for a single line, use the key board backward arrow. To improve the position on the image, use the zoom and directional arrows. We find the coordinates of the four calibration points in pixels:

(X,Y)=(80.3, 81.6), (982.3, 86.1), (978.9, 937.4), (71.2, 929.5).

The corresponding physical coordinates are known to be

(x,y)=(0,0),(58.8,0),(58.8,55.1),(0,55.1), with an origin (0,0) taken at the lower left (and z=0).

Introduce those in the two first columns of the table [!ListCoord]. This can be conveniently done by copy-paste Matlab vector x=[0 58.8 58.8 0] in the upper line of the x column, and y=[0 0 55.1 55.1] in the y column (use carriage return to validate the input). 

To perform the calibration, press '''APPLY''', first with the default option 'rescale' in '''calib_type'''. The image is now displayed in phys coordinates. We observe that the rectangular frame is slightly rotated. furthermore the displayed precision, about 3 pixels, is not excellent.

To improve the precision we then apply the option 'linear' in '''calib_type''', which seeks a general linear transform, including rotation. The precision is indeed improved, about 1 pixel. The previous xml file has been saved with a ~ ('Dalsa1.xml~') so it can be reverted in case of error.