Changes between Version 217 and Version 218 of UvmatHelp

Timestamp:

Dec 15, 2022, 8:11:48 PM (2 years ago)

Author:

sommeria

Comment:

--

UvmatHelp

@@ -621 +621 @@
 To  reproduce the same calibration for another image series, open one of the image  in the series, and apply again the calibration with the same points,  keeping the GUI geometry_calib opened.
 
-To calibrate at once a set of experiments, a better alternative is to select the check box '''[REPLICATE]'''. Open a folder  '''Campaign''', parent of the folders '''Experiment''' to treat. The GUI '''data_browser.fig''', also described in [#a3.7Dataorganisationinaproject section 3.7], then pops up. A two-column display appears, with the list of '''Experiments''' on the left and the list of corresponding '''[!DataSeries]''' on the right. Select the list of experiments to calibrate, and a single camera name in '''[!DataSeries]''', then validate by pressing '''[OK]'''.
-
+To calibrate at once a set of experiments, a better alternative is to select the check box '''[REPLICATE]'''. Open a folder  '''Campaign''', parent of the folders '''Experiment''' to treat. The GUI '''data_browser.fig''', also described in [#a3.7Dataorganisationinaproject section 3.7], then pops up. A three-column display appears, with the list of '''Experiments''' on the left, the list '''Devices''' (camera) at the middle,  and the list of corresponding '''[!DataSeries]''' on the right, see screen shot below. Select the list of experiments to calibrate, and a single camera name in '''[!DataSeries]''', then validate by pressing '''[OK]'''.
+
+[[Image(browse_data_small.jpg)]]